Dutymate X3 Enhanced

The Dutymate X3 Enhanced controls three units with fully automatic control sequencing that rotates the duty cycle based on the number of hours each unit has run. The Dutymate X3 Enhanced will monitor the motor starter and fault signals of each unit to provide full redundancy in the event of failure.  A Local/Remote switch that allows the Dutymate X3 Enhanced to run in a fully operational stand alone mode facilitating service and maintenance.

In addition to these features the Dutymate X3 allows for manual selection of duty cycle, providing automatic sequence starting, remote fault annunciation and a high demand mode that places both units in parallel as lead units.

This system can be customised to your specifications, such as incorporating motor starters, extra output points for status monitoring, RS232/422/485 data communications and interfacing to a SCADA I/F  package to make more information available to you than has ever been available previously.

The Dutymate X3 Enhanced system uses standard, readily available components.  Should you require specific brands or models of any equipment, this can be accommodated.